(!) For Vm voltages > 12V jumper J1 must be removed and a separate 5V supply connected the 5V terminal.įailure to observe the above conditions will result in permanent damage to the on-board regulator resulting in the motor supply voltage Vm being applied to the 5V terminal. (!) When using the 5V terminal as an output (J1 fitted) DO NOT draw more than 100mA from this terminal.

If J1 is removed a separate 5V supply connected to the 5V terminal is required to power the digital circuit.Īctual voltage across motor terminals = Vm - ~2.35V When J1 is fitted the input of the on-board 5V regulator is connected to Vm and the 5V terminal becomes an output. Screw terminals allow for easy connection of the motor(s) and the power supply.Ĭombined motor drive current (max): 2A for 2 minutes / 1A continuousĭimensions: (LxWxH): 43mm x 43mm x 27.5mm It includes an optional on-board 5V regulator for powering its internal logic circuit so only one supply voltage is required (Vm = 6 to 12V). Alternatively, the module is capable of driving a single 4 input stepper motor. The L298N driver module, using ST L298N chip, can directly drive two 3-30V DC motor, and provide a 5V output interface, power for 5V single-chip circuitry.

Two enable inputs are provided to enable or disable the device. It is a high voltage, high current dual full-bridge driver de-signed to accept standard TTL logic level sand drive inductive loads such as relays, solenoids, DC and stepping motors. This three terminal block with +12V, GND, and +5V. The L298N H-Bridge module has facilitate with additional external input power supply source to handling handle starting current requirement for both DC motor. This driver allows up two DC motors to be independently controlled in both forward and reverse directions via a microcontroller such as an Arduino. The L298N is an integrated monolithic circuit in a 15- lead Multiwatt and PowerSO20 packages. As specified in L298N H-Bridge module the motor driver has a two motor terminal block to connect DC motor.

The L298N motor drive module (HCROBO0068) contains a dual channel full H-bridge driver.

L298n motor driver info